Leather shoes used for a long time often have peeling soles, open toes or leather peeling at the edges. For a firm bond you must choose the right leather shoe adhesive and follow the right order: clean, apply adhesive to both surfaces, wait until tacky, then press. This article explains how to choose adhesive and how to bond leather shoes with Su Tu Vang 405A shoe adhesive.
Choosing leather shoe adhesive by material
| Place to bond | Recommended | Note |
|---|---|---|
| Leather or imitation leather to a rubber sole | Keo 405A | Lightly sand, apply adhesive to both surfaces |
| PU, PVC, TPR, EVA soles (smooth) | 405A adhesive with PU and PVC treatment agent | Surface treatment before applying adhesive |
| Heat-activated sports shoe soles | Keo PU HP-333 | See the separate guide on heat-activated PU adhesive |
Preparation before bonding
- Shoe adhesive, a small brush or an adhesive scraper.
- Fine sandpaper, a clean cloth, masking tape to cover leather that should not be bonded.
- Clamps or a rubber mallet to press.
How to bond leather shoes: 5 steps

- Clean. Scrape off old adhesive, wipe off dust, oil and shoe polish in the bonding area and let dry completely.
- Mask the areas not to be bonded. Apply paper tape right at the edge so adhesive does not smear on the leather face, especially on glossy leather shoes.
- Apply adhesive to both surfaces. Brush a thin, even layer of adhesive on both the leather and the sole, covering the edges.
- Wait until the adhesive turns tacky. Let the adhesive dry naturally for a few minutes until it feels tacky, sticky but not smearing on your hand.
- Press firmly. Align correctly then press from heel to toe, using clamps or a rubber mallet for even pressure. Let the adhesive settle before wearing the shoes.
Common mistakes when bonding leather shoes
- Adhesive smears onto the leather face: too much applied or the edge was not masked. Apply thinly and wipe off excess immediately.
- Peels again after bonding: the surface was still dirty or only one surface was coated.
- Leather edge still gaping: pressed unevenly. Press from heel to toe and re-check the edge.
Shoe adhesive prices
405A adhesive 3 kg can priced from 450,000 VND, contact us for a quote by quantity. See also: premium shoe adhesive, how to re-bond a peeled shoe sole, What is adhesive?
The prices above exclude 8% VAT. Prices shown in the store include VAT.
Frequently asked questions
What adhesive for peeled leather shoes?
Use dedicated shoe adhesive such as 405A. For PU, PVC, TPR and EVA soles, treat the surface before applying adhesive.
Is it necessary to apply adhesive to both surfaces?
Yes. Brush a thin layer on both the leather and the sole, wait until tacky and then press; only then will the bond be firm.
View all adhesive products Su Tu Vang industrial adhesives by material.



