Giảm giá!

Hydro-Block Sealant Chemical HS-PRO

500.000,0

  • HS-PRO is a water-proofing chemical that bonds to surfaces to create long-lasting finishes.

  • This sealant can be used for projects requiring waterproofing such as: construction of housing structures, basements, garages, restrooms, roofing, pools, fish tanks, and any other heavy-duty projects.

Danh mục:

Mô tả

Hydro-Block Sealant Chemical HS-PRO

     1. INTRODUCTION:

  • HS-PRO is a water-proofing chemical that bonds to surfaces to create long-lasting finishes.
  • This sealant can be used for projects requiring waterproofing such as: construction of housing structures, basements, garages, restrooms, roofing, pools, fish tanks, and any other heavy-duty projects.

     2. CHARACTERISTICS:

  • Sealant has a large-scale ability to expand and shrink. It is able to expand by 500% of its original size. This elasticity allows the sealant to last longer and accommodate possible movements to the surface.
  • Resistant to harsh conditions and weather: low or high temperatures, moisture, dryness.
  • Resistant to damaging chemicals like sulfuric acid, potassium chloride, and sulfate. This will prolong life-span of the applied sealant.
  • Free of benzene, toluene, xylene, and formaldehyde. These chemicals pose huge health and environmental risks. This sealant contains none of these chemicals.
  • Easy to use, just apply sealant to surface.

     3. INSTRUCTIONS:

  • Thoroughly clean and dry surface. Surface must be free of oils, dust, and chemicals.
  • Using a brush, apply the product as evenly as possible to desired surface.
  • Allow the chemical to dry for 30-60 minutes before recoating.
  • Allow for 24 hours to dry to completion, and before product can be used again.
  • Do not allow moisture on applied sealant before it is fully dried.

     4. ATTENTION:

  • Do not allow for freshly applied sealant to get wet. For best results, keep moisture away from surface until sealant is fully dried (24 hours).
  • Check for bubbles and cracks after applying sealant and reapply sealant in necessary places before allowing it to fully dry.
  • Apply sealant near corners with extra care, use straight and even strokes.
  • 1m2 uses 1.25 kg of the sealant with 1 mm density.
  • Mix the sealant thoroughly before use to ensure the product is ready to be applied.

      5. STORAGE:

  • Seal tightly to store.
  • If not sealed, use within 30 minutes to avoid hardening.
  • Mix well before use.
  • If a film forms on surface of stored product, scrape the film off before use.

 The Hydro-Block Sealant uses top-tier technology developed within the field of heavy-duty construction. It is among the most advanced sealants available in store that is free of health and environmental risks, has incredible bonding strength, and extremely water-proofing abilities.